Commercial · Kitchen ventilation
Rangehoods and exhaust fans for commercial kitchens: installed to suit the cooking line, and repaired when airflow drops or fans fail.
Airmax installs and repairs commercial kitchen rangehoods and exhaust systems in Melbourne, including canopies, exhaust fans and ductwork. We also fix airflow, noise and fan or control faults. We don't offer exhaust cleaning or fire suppression work.
We work across Melbourne and regional Victoria. Every job starts with a written quote.
The size and position of a rangehood depends on the cooking equipment beneath it and how the kitchen is laid out. We look at the cooking line, the heat and grease it produces, and where exhaust can be discharged.
Installation covers the canopy, the exhaust fan, and the ductwork between them and the discharge point. The scope is set out in your quote, including any make-up air, electrical and builder's work that's needed.
Common exhaust problems are smoke and heat not clearing, loud or vibrating fans, fans that won't start or run slowly, and control faults. We diagnose the cause, whether it's the fan motor, belts, bearings, controls or the ductwork.
Kitchen exhaust work often involves roof access and has to fit around trading hours. We plan access and timing with you. After installation or repair we run the system and check airflow.
Fans and motors wear over time. Tell us about your cooking equipment, the existing exhaust system and any faults, with photos, and we'll advise on repair, replacement or maintenance.
Send the site, equipment, make and model, the fault or project goal and access details.
We inspect the equipment and site, identify the assets involved and note access and operating constraints.
You get a written scope and quotation for approval, including exclusions and timing.
We carry out the approved work, coordinated around your trading hours and site rules.
We test and commission the equipment, report what we did and note any follow-up.
More answers on our FAQ page.
The cooking equipment under the canopy, the kitchen layout and dimensions, the route to the discharge point, and any existing exhaust equipment. Photos and a site visit fill in the details.
Yes. Depending on the fault, we may replace the motor, belts or bearings, or the whole fan. We diagnose the fault first and quote the options.
Replacement of fan motors, electric and defrost heaters, controllers, sensors and electrical parts after diagnosis.
New and replacement HVAC for business premises, including ductwork, heating, controls and commissioning.
Diagnosis and repair of commercial cooling, heating, airflow, duct and control faults.
Fill this in and we’ll get back to you with a quote or a time to visit.
AU55285
PL111226Licensed technicians for refrigerant, plumbing and electrical work
Full public liability cover on every job
Workmanship guarantee on all installations
A written quote before any work starts
Offices, retail, hospitality and facilities. Design, installation and maintenance under one contract.
